D-Link Forums

The Graveyard - Products No Longer Supported => Routers / COVR => DIR-605L => Topic started by: rohitjaiswal on October 04, 2013, 11:48:14 PM

Title: How to Get 300Mbps Link Speed in DIR_605L???
Post by: rohitjaiswal on October 04, 2013, 11:48:14 PM

hello  sir, 
i have purchased  this  dir-605L  two days back  for  better  performance than Dir-600L. 

I bought  605L for getting 300mbps speed  but still i am getting maximum of 150mbps.
please  tell me  how  to  configure it  for  getting 300mbps.

Regards,
Rohit.

Title: Re: How to Get 300Mbps Link Speed in DIR_605L???
Post by: FurryNutz on October 05, 2013, 11:11:47 AM

• 2.4Ghz Routers only: Try single mode N
• Channel Width set for Auto 20/40Mhz
• Try setting a manual Channel (http://en.wikipedia.org/wiki/Wireless_channel) to a open or unused channel. 1, 6 or 11. 11 for single mode N if the channel is clear.
• What security mode are you using? Preferred security is WPA-Personal. WPA2/AES Only.
• If you have any of these options, Try turning OFF or ON Short GI (http://www.smallnetbuilder.com/wireless/wireless-features/30969-what-do-80211ns-optional-features-mean-for-you), WLAN Partition, HT 20/40 Co-exhistance and Extra Wireless Protection if you have it. Recommended settings are default. Under Advanced/Advanced Wireless.
• Enable WMM Enable (http://forums.dlink.com/index.php?topic=50738.0) Under Advanced/Advanced Wireless.
• Try setting Medium or Low power output settings and test again Under Advanced/Advanced Wireless.

You'll need to check with the device client Mfr to see weather or not those devices you connect are supporting of 300Mb WiFi connections on 2.4Ghz.