D-Link Forums

Software => D-ViewCam => Topic started by: mtarallo on November 20, 2013, 04:35:05 PM

Title: The program will be restarted to apply a new setting
Post by: mtarallo on November 20, 2013, 04:35:05 PM

I found this document: ftp://files.dlink.com.au/products/DCS-942L/REV_A/SetupGuides/How_to_record_using_mydlink_cameras.pdf - I installed D-ViewCam and all i get is this message each time I log in to the MainConsole: The program will be restarted to apply a new setting.

I found this: http://forums.dlink.com/index.php?topic=51349.0

None of the suggestions have helped.

Windows 7 64 bit.

Any more ideas - DLINK?

Title: Re: The program will be restarted to apply a new setting
Post by: 06lemansC6 on November 27, 2013, 05:00:01 AM

Good luck. I'm still searching for an answer to this one. I installed it on an older 32 bit with XP and it works fine. It looks like this issue was brought up months ago yet D-link still has no cure.  >:(

Title: Re: The program will be restarted to apply a new setting
Post by: FTLOSM on February 07, 2014, 04:23:42 PM

I can't seem to get past this to save my life!  I tried all the suggestions given in the link of the OP here but so far all I get is that loop of the program asking me to sign in then disconnecting, restarting and asking me to sign in again!

I can view both cameras via iphone and browser fine, but I want the d viewer on so I can RECORD them.

Has anyone found a solution to this and where the heck is DLINK on this!?!?

NOT happy...