D-Link Forums

The Graveyard - Products No Longer Supported => D-Link Storage => DNS-323 => Topic started by: Zappy on May 24, 2009, 05:58:35 PM

Title: Help on Setup: Can't get to click Configure
Post by: Zappy on May 24, 2009, 05:58:35 PM

Hi,

Hope someone could shine some light. After hooking up, click Refresh and the IP address was detected.

Once I click onto the IP address, the Configure button grey out immediately!

Try typing the IP address in IE but can't access to the admin web page.

(http://img30.imageshack.us/img30/2185/capture01e.jpg)

Thank you for your kind attention.

Title: Re: Help on Setup: Can't get to click Configure
Post by: lizzi555 on May 24, 2009, 08:19:25 PM

What is your own network ? Is it in the same range as the address 192.168.0.32 of the DNS-323 ?

Try running Start -> Run -> CMD -> ipconfig /all

and see which address your network card connected to the DNS reverts back.
If it not starts with 192.168.0. you have to assign an address manually.

Title: Re: Help on Setup: Can't get to click Configure
Post by: Zappy on May 24, 2009, 08:40:24 PM

oh yes.... thank you so much. manage to change the IP address & format my hard disk etc.

(http://img505.imageshack.us/img505/7613/step03seting.jpg)

Will try hooking up my wireless router to see if I could get connected up tonite.

Thank you for your reply.