D-Link Forums

The Graveyard - Products No Longer Supported => D-Link Storage => DNS-320L => Topic started by: Kraker01 on December 17, 2013, 12:44:05 PM

Title: New 320L and new WD40EZRX-00SPEB0
Post by: Kraker01 on December 17, 2013, 12:44:05 PM

Hi,

is 320L supporting this Hard Disk?

I've ordered both of them but I can't find how to configure the NAS with the Hard Disk because the button Set RAIDType and Re-format is greyed out. I've tried the scan disk and it passed so i think it's a formatting problem.

I've attached it to my computer and I've converted it to MBR with 2 partition, one NTFS and the other one unused. Is this a problem? Should i format in EXt4/5?

How can I fix that? I'm on a new 1.03 firmware revision A3

Title: Re: New 320L and new WD40EZRX-00SPEB0
Post by: Kraker01 on December 18, 2013, 01:23:06 PM

Any help?

Title: Re: New 320L and new WD40EZRX-00SPEB0
Post by: koadrian on December 19, 2013, 08:16:11 AM

EXT5 try it.

Title: Re: New 320L and new WD40EZRX-00SPEB0
Post by: pizzaking on December 19, 2013, 09:00:41 AM

You can only format the drive through the NAS, if you want it to work. My guess is that you did not push the drive thoroughly down the slot, so that it's properly connected.

Do you hear the drive spinning when starting the NAS, and do you see the blue LED-light on the front which indicate that the hard drive is connected?