D-Link Forums
The Graveyard - Products No Longer Supported => IP Cameras => DCS-2332L => Topic started by: ColtzNut on February 03, 2014, 12:18:05 PM
-
I have 3 cameras on my network and for some reason cannot look at one of them on my iPad. I can see the other 2, so i know the network is fine. I also can remote into a PC at home and look at the camera on a PC at home. Works fine there. When I click on the camera on the iPad, I get the following error message.
Relay Connection error
Could not connect to the device. Please try again later (Error 208)
OK
As I said, the other 2 cameras in the app work fine when I click on them. Thoughts?
-
Did you ever find a solution to this? I have a single DCS-2132L that I can connect to just fine as long as I am at home on the same wireless network (using the myDlink Lite app Locally, Remote, as well as the website) but when I attempt to access the camera from another work, I get Relay Connection errors (error 208) or an Unable to connect (0.70_0_2_8_0)
If I have someone reboot the camera, it will work for a bit, but then after a few minutes it will disconnect me and upon attempts to reconnect I get the same errors. Were you getting similar and if so did you find a solution?