D-Link Forums
The Graveyard - Products No Longer Supported => IP Cameras => DCS-932L => Topic started by: ptarrinho on February 18, 2014, 03:42:57 PM
-
Hello there,
I have 4 DCS-932L cameras, I've installed recently the "MyDlink" app and was asked to upgrade the firmware.
I've done it to all, but I'm having a problem with 3 out of 4 that they are not working.
I've been testing with one, in the same room as the Access Point, and looks like its rebooting continually.
Out it works:
"Red - 15 seconds
Green with out blinking - 1 minute
Red - 5 seconds
Red Blinking - 5 seconds -
Red - 15 seconds
Green with out blinking " Whenever I'm near the camera, it detects that I am there.
One Important information is that if the camera is closer to the AP, ou via ethernet, it works. I have also another camera, further away, and its working.
The other 2 cameras, are a little far away and just stay red, although before the upgrade they used to work (direct access via http)
I hope someone can help me.
-
Can you access the problematic cameras directly via IP address using a browser on a PC in your LAN? If not, try powering down the cameras (pull the power cord) and reboot.
If all else fails, you can try performing a factory reset. While the DCS-932L is powered-up, press and hold the recessed Reset button on the rear of the camera using a paperclip for > 9 seconds. This procedure will delete all user settings.
-
"The other 2 cameras, are a little far away and just stay red, although before the upgrade they used to work (direct access via http)"
I'm wondering if the firmware upgrade was done over WiFi - any interruption could have bricked the cameras if the procedure was not done wired
-
Were you able to make any headway with this issue? :-\