D-Link Forums

The Graveyard - Products No Longer Supported => D-Link NetDefend Firewalls => Topic started by: locsom20 on June 03, 2009, 03:12:45 PM

Title: I can`t config DFL-210 Filtering web URL
Post by: locsom20 on June 03, 2009, 03:12:45 PM

I followed the instructions to enable this filter, ( In the examle www.yahoo.com is been blocked)

ftp://ftp.dlink.pl/dfl/dfl-800_1600_2500/documentation/DFL-210_800_1600_2500_howto_en_How-to-configure-HTTP-ALG-for-Web-URL-filter_20070205.pdf

But I only get the filter of all the URL, I can´t see any web page. My firewall is the DFL-210 my firmware is 2.20.01.05-4843 Feb8 2008,.
I reset the firewall to factory, but I get the same result.... Anydoby has make this filtering??? Please I need help about this. Maybe you can send my a diferent method to do this filtering.

Title: Re: I can`t config DFL-210 Filtering web URL
Post by: Fatman on June 03, 2009, 03:36:33 PM

I would try changing the IP rule they have you set to action NAT and destination interface WAN.  That would make a lot more sense in non-lab environments.

Title: Re: I can`t config DFL-210 Filtering web URL
Post by: locsom20 on June 04, 2009, 10:00:20 AM

I change the allow to NAT, and I use de http service with a new ALG. I dont use the http_outbound ALG. Now all is working great!!!
Thanks!!!
I have another question but, I better put it in a new topic.