D-Link Forums
The Graveyard - Products No Longer Supported => IP Cameras => DCS-942L => Topic started by: Jennifer Waters on March 12, 2014, 09:07:33 AM
-
It's been working fine for the past few months since I bought it, I'm not sure what happened but when I last went to use it the red light was on. I downloaded the latest firmware and tried to run the Mac OS set up wizard but couldn't get past the required password. It continues to tell me my password is wrong but I'm certain it's not, I can log into the website fine. I tried selecting "forgot password" and get a popup again advising me to reset hold down the reset button, but I never get anywhere with this command. I can only get it to work when connected to my router but once I unplug it, it's back to red. What can I do to fix this, I've been trying to figure this out forever and I'm really ready to throw it right now >:(
-
The Setup Wizard that came with your camera will most likely not work with newer firmware versions. I recommend visiting the mydlink.com/support site and downloading the latest Setup Wizard application. If this doesn't work, then try performing a factory reset:
The link to the factory reset procedure is posted here: Network Cameras - Important Posts & Information (http://forums.dlink.com/index.php?topic=58121.0)
Post back and let us know how everything turns out.