D-Link Forums

The Graveyard - Products No Longer Supported => IP Cameras => DCS-930L => Topic started by: kickassmax on March 20, 2014, 08:57:17 AM

Title: dcs-930l
Post by: kickassmax on March 20, 2014, 08:57:17 AM

good day, I had a problem with my dcs-930L camera, which can not connect to the network, I have restored the factory settings the same with the reset button, but when I get to set the password tells me the following phrase "a problem occurred while saving changes. then click Next to try again" I restarted many times the camera I tried this several times but without success also. I hope you can help me. regards

Matias Olsen

Title: Re: dcs-930l
Post by: JavaLawyer on March 20, 2014, 09:24:13 AM

what firmware version are you using?
Are you using the Setup Wizard that came with the camera or a version you downloaded from D-Link?

Title: Re: dcs-930l
Post by: Jim1590 on March 20, 2014, 01:04:13 PM

I had this issue and it was either a firmare / install software version mismatch or a problem with saving the password. Most likely it is the mismatch. However if they match, use the WPS button.