D-Link Forums

The Graveyard - Products No Longer Supported => IP Cameras => DCS-942L => Topic started by: Mari_elli on March 29, 2014, 12:33:57 PM

Title: DCS-942L doesn't reset
Post by: Mari_elli on March 29, 2014, 12:33:57 PM

Hi, I have a problem with my camera and I hope someone could help me.  I installed it
and could see the image well. But then I want to see the image through my iphone and appears a message
that said that I have to install the latest version of the firmware... so the light of the camera turn red and despite I press the reset button (at the back of the camera) while the power supply and the Ethernet cable are connect it doesn't work and still red (it doesn´t turn green or blue just stay red). Please help me and tell
what else I can do. Thanks

Title: Re: DCS-942L doesn't reset
Post by: JavaLawyer on March 29, 2014, 12:38:20 PM

Quote from: Mari_elli on March 29, 2014, 12:33:57 PM

Hi, I have a problem with my camera and I hope someone could help me.  I installed it
and could see the image well. But then I want to see the image through my iphone and appears a message
that said that I have to install the latest version of the firmware... so the light of the camera turn red and despite I press the reset button (at the back of the camera) while the power supply and the Ethernet cable are connect it doesn't work and still red (it doesn´t turn green or blue just stay red). Please help me and tell
what else I can do. Thanks

Can you access the DCS-942L by entering the camera's IP address in a browser on a PC located on the same LAN as the camera?

Title: Re: DCS-942L doesn't reset
Post by: RYAT3 on March 29, 2014, 03:39:28 PM

Quote from: Mari_elli on March 29, 2014, 12:33:57 PM

But then I want to see the image through my iphone and appears a message
that said that I have to install the latest version of the firmware...

You said yes to install latest firm ware from your iPhone?

Title: Re: DCS-942L doesn't reset
Post by: JavaLawyer on March 30, 2014, 10:32:45 AM

Any update on this issue?  ???

Title: Re: DCS-942L doesn't reset
Post by: Mari_elli on March 31, 2014, 05:35:59 PM

No, I couldn't installed the latest firmware.... when I try to see the image of the camera through my iphone it show a message that said that I have to installed it but the camera was with the red light already

Title: Re: DCS-942L doesn't reset
Post by: JavaLawyer on April 01, 2014, 04:37:36 AM

Did you try performing a factory reset and reconfiguring the device?
DCS Network Cameras - Factory Reset Procedure (http://forums.dlink.com/index.php?topic=47707.0)

Title: Re: DCS-942L doesn't reset
Post by: Mari_elli on April 01, 2014, 07:41:01 PM

Yes, I try reset the camera pressing the button (for a minute) at the back plenty of times and the red light didn't change.

Title: Re: DCS-942L doesn't reset
Post by: JavaLawyer on April 02, 2014, 04:31:38 AM

Can you access the DCS-942L by entering the camera's IP address in a browser on a PC located on the same LAN as the camera? (Try this through a wired connection if wireless does not work)