D-Link Forums
The Graveyard - Products No Longer Supported => IP Cameras => DCS-942L => Topic started by: nolalala on April 30, 2014, 04:21:50 PM
-
Factory Reset Procedure
To reset your DCS-942L network camera to the factory setting, while powered-down, press and hold the "Reset" button on the rear of the camera for at least 10 seconds.
Connect the power-cord, press and hold the "Reset" button while also holding the "WPS" button on the rear of the camera for another 10 seconds.
ANY configuration from the DCS-942L at this point will be lost.
Please do not delete this post again.
kthxbb