D-Link Forums
The Graveyard - Products No Longer Supported => Routers / COVR => DIR-600L => Topic started by: vivekaro on May 17, 2014, 10:42:23 AM
-
I am currently using SSV broadband internet service (www.i-on.in). They have done server update after which I am unable to use my router. Each time I try to log in, the POP3 setting to verify my account does not grant me access. I have checked with the service provider and as per them the solution for this issue is to change my router to TP Link.
I have recently bought this router and do not wish to buy another one, not sure if that will work too. Can someone assist me to solve this issue.
Thanks in advance.
-
Link>Welcome! (http://forums.dlink.com/index.php?topic=48135.0)
- What Hardware version is your router? Look at sticker under router.
- Link>What Firmware (http://forums.dlink.com/index.php?topic=47512.0) version is currently loaded? Found on the routers web page under status.
- What region are you located?
- Are you wired or wireless connected to the router?
- Has a Factory Reset (http://blog.dlink.com/what-is-a-reset-button-when-should-i-use-it) been performed?
Internet Service Provider and Modem Configurations
- What ISP Service do you have? Cable or DSL?
- What ISP Modem Mfr. and model # do you have?
- Is ISP Modem/Service using Dynamic or Static WAN IP addressing?
- What ISP Modem service link speeds UP and Down do you have?
- Check cable between Modem and Router, swap out to be sure. Link> Cat6 is recommended. (http://en.wikipedia.org/wiki/CAT6)
- If this modem has a built in router, it's best to bridge the modem. Having 2 routers on the same line can cause connection problems: Link>Double NAT (http://www.practicallynetworked.com/networking/fixing_double_nat.htm) and How NAT Works (http://cognitiveanomalies.com/cisco-nat-how-nat-works/). To tell if the modem is bridged or not, look at the routers web page, Status/Device Info/Wan Section, if there is a 192.168.0.# address in the WAN IP address field, then the modem is not bridged. If the modem can't be bridged then see if the modem has a DMZ option and input the IP address the router gets from the modem and put that into the modems DMZ. Also check the routers DHCP IP address maybe conflicting with the ISP modems IP address 192.168.0.1. Check to see if this is the same on the ISP modem and if modem can't be bridged. If so, change the DIR router to 192.168.1.1 or .0.254.
Example of a D-Link router configured for PPPoE with ISP Modem bridged: PPPoE Configuration on Router (http://forums.dlink.com/index.php?topic=56344.msg219023#msg219023) - Check ISP MTU requirements, Cable is usually 1500, DSL is around 1492 down to 1472. Call the ISP and ask. Link>Checking MTU Values (http://forums.dlink.com/index.php?topic=53008.0)
- For DSL/PPPoE connections on the router, ensure that "Always ON" option is enabled.
-
Any Status on this? ???
I am currently using SSV broadband internet service (www.i-on.in). They have done server update after which I am unable to use my router. Each time I try to log in, the POP3 setting to verify my account does not grant me access. I have checked with the service provider and as per them the solution for this issue is to change my router to TP Link.
I have recently bought this router and do not wish to buy another one, not sure if that will work too. Can someone assist me to solve this issue.
Thanks in advance.