D-Link Forums

The Graveyard - Products No Longer Supported => Hubs and Switches => DGS-1248T => Topic started by: issak on May 26, 2014, 02:40:12 AM

Title: 1510-28 management vlan?
Post by: issak on May 26, 2014, 02:40:12 AM

Is there a way to set management vlan?
On HP there is a very nice setting under 'Setup network' that says 'Management VLAN ID', is there a similar setting on D-link?
Now the switch is accessible only on ports that are untagged for VLAN1, I'd like it to be accessible trough vlan 200.

Title: Re: 1510-28 management vlan?
Post by: lystor on June 16, 2014, 03:35:03 AM

Quote from: issak on May 26, 2014, 02:40:12 AM

Is there a way to set management vlan?
On HP there is a very nice setting under 'Setup network' that says 'Management VLAN ID', is there a similar setting on D-link?
Now the switch is accessible only on ports that are untagged for VLAN1, I'd like it to be accessible trough vlan 200.

Hi, issak

Assign IP address to VLAN 200 interface ad check routing table.

See:

1) D-Link DGS-1510-28 User Manual -> IPv4 Interface:
http://dlink-manuals.org/dlink-dgs-1510-20-28-28p-52-user-manual/143/

2) D-Link DGS-1510-28 User Manual -> IPv4 Route Table
http://dlink-manuals.org/dlink-dgs-1510-20-28-28p-52-user-manual/146/