D-Link Forums
The Graveyard - Products No Longer Supported => D-Link Storage => DNS-323 => Topic started by: asamalikum on June 24, 2009, 08:24:35 AM
-
Hi, i just bought a new NAS (Dlink 323). After hardware set up, i'm suppose to configure the system by accessing the configuration on WEB UI. Therefore i figure out the NAS ip address from the DHCP client list on my router settings. Hence i type in http://192.168.1.35/ (1.35 being the address of NAS) and it keeps on loading and loading, yet nothing comes out. I'm not sure how should i set this up. Please help.
-
Try using a ping utility in Mac and try to ping the IP address of the DNS-323. Sorry I don't know were this utility is located off hand I don't use Mac all that much.
-
On your mac, open up the Terminal app (this gives you command line access). Then ping the NAS:
ping 192.168.1.35
If you get replies, then it is on the network. If not, then you either have the wrong IP address or something else is wrong. Good luck.
-
thank you. it does reply on the 192.168.1.35, what do i do next?
-
Try powering the unit down and back on. If that fails try resetting the unit to factory defaults using the reset button on the back. Press and hold for about 5 seconds. You may need a paper clip to press it in.
-
I already answered your post on the other forum, but, in a nutshell, you either have a networking or browser problem. Shouldn't have anything to do with it being a Mac.