D-Link Forums
The Graveyard - Products No Longer Supported => IP Cameras => DCS-932L => Topic started by: ioria on December 31, 2014, 07:35:30 AM
-
Hi,
this is a rev B camera. I tried to configure with wizard, but camera is not recognized. Disabled any antivirus of firewall and this is network configuration --> https://drive.google.com/file/d/0B3pgeQ_qwsiaOGNDYzJ4NGZRNGM/view?usp=sharing (https://drive.google.com/file/d/0B3pgeQ_qwsiaOGNDYzJ4NGZRNGM/view?usp=sharing).
In red circle there is camera and pc from where I am trying reach it.
Thanks a lot for any support.
Regards.
Ioria.
-
Can you access the camera via the DCS-932L IP address using a browser on a PC located in the same LAN?
-
Hi Jl,
yes, I can. looking at the picture i posted from 192.168.1.100 I typed form IE http://192.168.1.104 and a login form is prompt.
witch userid/pass i should you to log in?
BTW, even if i can reach (I can also ping the camera), wizard doesn't work. How to solve it? How can i configure it?
Thanks.
Ioria.
-
**
"witch userid/pass i should use to log in?"
Sorry for my english... ;D
-
The default username and password for a new camera is username: admin; password: [blank]. You can configure the camera manually, get the wireless settings working properly and then perhaps the Wizard will work.
Where did you get the version of the Wizard that you're using? There are dependencies between the Wizard version and installed FW version. Legacy Wizard versions may not work with newer firmware.
-
You may find the following post useful: Network Cameras - Important Posts & Information (http://forums.dlink.com/index.php?topic=58121.0)