D-Link Forums

The Graveyard - Products No Longer Supported => Routers / COVR => DIR-860L => Topic started by: TFlett on February 16, 2015, 07:15:34 PM

Title: Setting up an Second Router
Post by: TFlett on February 16, 2015, 07:15:34 PM

I recently purchased a D-Link AC 1200 to add to my D-link-8900 so that we can get faster internet. I am planning on turning the D-link 8900 an AP, one of the steps it asks me is to disable my UPnP, DHCP, and WAN denpendant featurettes. But the thing is I don't know how to go about it. Which page should I disable them in. Or how to change the LAN IP address. I'm not that good at internet tech. 

Title: Re: Setting up an Second Router
Post by: FurryNutz on February 17, 2015, 07:18:28 AM

Link>Welcome! (http://forums.dlink.com/index.php?topic=48135.0)

• What Hardware version is your router? Look at sticker under the router case.
• Link>What Firmware (http://forums.dlink.com/index.php?topic=47512.0) version is currently loaded? Found on the routers web page under status.
• What region are you located?

Can you confirm the model # information of the D-Link 8900? Is this a Router or a Modem?

Title: Re: Setting up an Second Router
Post by: FurryNutz on February 20, 2015, 09:15:32 AM

Any status on this?  ???

Quote from: TFlett on February 16, 2015, 07:15:34 PM

I recently purchased a D-Link AC 1200 to add to my D-link-8900 so that we can get faster internet. I am planning on turning the D-link 8900 an AP, one of the steps it asks me is to disable my UPnP, DHCP, and WAN denpendant featurettes. But the thing is I don't know how to go about it. Which page should I disable them in. Or how to change the LAN IP address. I'm not that good at internet tech.