D-Link Forums

The Graveyard - Products No Longer Supported => Routers / COVR => DIR-825 => Topic started by: cyadvert on June 01, 2015, 07:41:18 PM

Title: Access Controls fails on restart
Post by: cyadvert on June 01, 2015, 07:41:18 PM

Have DIR-825 setup for my local network.

I've setup some rules within Access Control section. But whenever a routers restarts, the sections are not in affect.
I do see all the access rules I've setup before, they stay. They just do not apply.
If I go in, rename (change ANYTHING), save the settings. Router takes 15 seconds to save/setup and then the control are in affect.

In other words, if the router gets restarted anyhow, I have to re-save all my previously Access Controls rules one-by-one for them to start working.

So, the question is, why is that the settings are there, but not in affect on restart?

Any idea?

Thanks

Title: Re: Access Controls fails on restart
Post by: FurryNutz on June 02, 2015, 09:02:45 AM

Link>Welcome! (http://forums.dlink.com/index.php?topic=48135.0)

What Hardware version is your router? Look at sticker under the router case.
Link>What Firmware (http://forums.dlink.com/index.php?topic=47512.0) version is currently loaded? Found on the routers web page under status.
What region are you located?

Can you post screen captures of your Access control and scheduling configurations? Adding Screenshots In A Post (http://forums.dlink.com/index.php?topic=58120.0)

Router Access Control, Blocking, Web Filters and Scheduling FAQ (http://forums.dlink.com/index.php?topic=56479.0)
To set up scheduling:
1. Reserve device IP addresses ON the router under Setup/Networking.
2. Set up a schedule under Tools/Schedule on the routers web page. Customize your dates and times here.
3. Use Advanced/Access Control configured and apply the customized schedule to a policy and to the PC(s) or device(s) desired to be controlled.
4. Ensure Time is set correctly on the router. Tools/Time.

I do believe Setup/Networking/DNS Relay and or Setup/Internet/Manual/Advanced DNS Services need to be enabled along with configuring Reserved IP addresses, Scheduling, and Access Controls.