D-Link Forums

The Graveyard - Products No Longer Supported => D-Link Storage => DNS-321 => Topic started by: rex21c on July 05, 2009, 08:01:40 PM

Title: network access list empty
Post by: rex21c on July 05, 2009, 08:01:40 PM

Whenever the unit is powered down or i lose power, my network access list is emptied, none of the mapped drives work on any of my 3 systems, and i have to put in users all over again, and remap all the computers on the network.  i'm applying the 1.01 patch, but if this does not work is there any suggestions or something im doing wrong.

Title: Re: network access list empty
Post by: ECF on July 06, 2009, 04:49:35 PM

Try the beta code 1.03?? The unit may be defective at that point. If you power the unit down then back up properly are the settings erased as well?

Title: Re: network access list empty
Post by: rex21c on July 07, 2009, 06:44:06 AM

no when i shutdown via the menu in IE and power back up all the settings are still there, it seems to only happen when power goes out, or somebody holds down the power button till it turns off.

Title: Re: network access list empty
Post by: ECF on July 07, 2009, 09:23:56 AM

Holding down the power button should still be a proper shut down. I would recommend trying out the beta code. Please be sure to reset the unit to factory defaults and reconfigure after the update.

Title: Re: network access list empty
Post by: rex21c on July 13, 2009, 07:19:30 AM

sorry for the late reply, it looks like the beta 1.03 did the trick, and the HD is powering down again. 

Thank You very much

Title: Re: network access list empty
Post by: bangelus on July 17, 2009, 06:35:49 PM

I had this issue initially with the default 1.00 firmware...upgrading to 1.01 did resolve this issue for me.
Hope that helps...