D-Link Forums
The Graveyard - Products No Longer Supported => Routers / COVR => DIR-615 => Topic started by: gugahb on August 05, 2015, 10:33:49 AM
-
I have a Router D-Link DIR 615 - Firmware Version 20.06, but the network is too slow, I did some testing LAN and ping it to the router, and it is absurd to sway and response time reaching 17ms, this network internal, I found it very strange, it was with the Firmware 20.04 I decided to upgrade and reset the factory settings to see if it would solve the problem, but still the same.
Here in the room have a Dlink 524 my ping test is fixed to 1.xx ms min with variations: min 0.912 max 1.281ms
Thank you all
-
Link>Welcome! (http://forums.dlink.com/index.php?topic=48135.0)
Please re-confirm actual FW version numbers please. v6.20 or 20.06?
- What region are you located?
- Are you wired or wireless connected to the router?
- Has a Factory Reset (http://blog.dlink.com/what-is-a-reset-button-when-should-i-use-it) been performed?
- Was a Factory Reset performed before and after any firmware updates then set up from scratch?
Link> >FW Update Process (http://forums.dlink.com/index.php?topic=42457.0)
- Was the router working before any firmware updates?
Internet Service Provider and Modem Configurations
- What ISP Service do you have? Cable or DSL?
- What ISP Modem Mfr. and model # do you have?
- Is ISP Modem/Service using Dynamic or Static WAN IP addressing?
- What ISP Modem service link speeds UP and Down do you have? Link> Speed Testing Sites (http://forums.dlink.com/index.php?topic=48352.0)
- Check cable between Modem and Router, swap out to be sure. Link> Cat6 is recommended. (http://en.wikipedia.org/wiki/CAT6)
- Check ISP MTU requirements, Cable is usually 1500, DSL is around 1492 down to 1472. Call the ISP and ask. Link>Checking MTU Values (http://forums.dlink.com/index.php?topic=53008.0)