D-Link Forums
The Graveyard - Products No Longer Supported => Routers / COVR => DIR-655 => Topic started by: emcp on August 15, 2015, 10:15:56 PM
-
Hi, I'm in a bit of a unique situation.. and the DIR655 router doesn't seem to want to do what I am expecting..
I have a Raspberry Pi , it is
- running Raspbian (Debian)
- properly configured to connect to an internet enabled wifi network (Let's call it N1).
- pass that internet traffic to it's eth0 interface.. allowing whomever connects via eth0 to access N1 (and the internet)
I want, the DIR655 to plug into the Raspberry Pi via ethernet on it's 'internet' port. detect the internet from eth0.. and then act as a DHCP server for a whole other access point (let's call it N2)...
Right now I can connect to N2, but there's no internet capabilities... I think I need to properly configure something but unsure what. I see the instructions for bridge mode http://forums.dlink.com/index.php?topic=40856.0 .. but my situation is a little different. I don't want to disable DHCP on the DIR655 at all.. in fact it should be running it's DHCP, and treat the Raspberry Pi almost like a cable modem.
-
SUCCESS!
So for those who also try this...
you need to get the N2 DIR655's DHCP server to stop trying to assign addresses within 192.168.0.# range..
I reconfigured the DIR655 to occupy 192.168.1.1, and assign across 192.168.1.100 to 199
I turned off UPNP as well.. not sure it mattered.
Once I got off that range, I easily could get new clients on N2 talking to the Raspberry Pi, and subsequently the internet.
-
Thank you for sharing this information. Glad you got it working. Hope this helps future users.
Enjoy. ;)