D-Link Forums
The Graveyard - Products No Longer Supported => IP Cameras => DCS-932L => Topic started by: spike72 on September 21, 2015, 06:09:55 PM
-
I have four 932L's two hardware ver A and two hardware ver B. After updating firmware on all four cameras the B cameras have had no issues . The A ver camera's seem to lose connection every hour or so. When I did the firm ware updates camera's were connected with Ethernet cable and pugged in to power source. When mounted in viewing location camera's use my Wi-Fi network. When I first noticed this I unplugged camera and reconnected I would get green LED but would not blink as I am recording to a DNR 202L.I have reset camera's to factory spec in camera web page I have also reset camera buy holding down reset on back of camera. I have also reinstalled firmware. I thought I had it corrected but today I notice again both A ver camera's the green LED is on solid they don't show up in my network and on MyDlink.com they show as being offline. I have to go thru the camera setup to get them back online . Again this is only on my two A version camera's and after the firmware update. How do I roll back to the previous firmware version. I was out of town for almost two weeks and while across the US I would check my camera's it would tell me theres a fireware update I would check install later and there was my video. Now after firmware update can't go a whole day with out loosing connection. I have updated firmware on router Everything was working last night got up this morning. only one camera lost connection. Am I the only person having issues after last firmware update. I find it hard to belive. No issues with camera's until update
-
Link>Welcome! (http://forums.dlink.com/index.php?topic=48135.0)
- What region are you located?
Was a factory reset performed before and after the FW was updated then setup from scratch?
I recommend using a Static IP address ON the DCS set to 192.168.#.32 or .93.
What Mfr and model is the main host router?
What wireless modes are you using?
What is the distance between the Camera and the main host router?
-
I'm in San Francisco bay area. I have static ip 110 Yes factory reset was done before and after firmware update I will try your IP suggestion camera now works a day or two before dropping out of my network. I have a TP link AC 1750 router with lastest firmware I only have an issue with one camera now the other 932L hardware ver A1 seems to be ok hasn't lost connection in a week now . Again never had any issues with cameras until last update and have no issues with any of the other 10 to 12 devices on my network. I don't remember what the wireless modes are but I remember going thru the forums and finding those settings suggestions 'ie' channel , security so forth and changing them to the recommended settings
-
Ensure uPnP and uPnP Port Forwarding is enabled on BOTH cameras.
-
I updated mine and it works fine. I do not have UPnP or UPnP Port Forwarding enabled.
-
Let us know any other information regarding how you have yours set up. Please feel free to help out users get theres going please.
Thank you for your time.
I updated mine and it works fine. I do not have UPnP or UPnP Port Forwarding enabled.