D-Link Forums

The Graveyard - Products No Longer Supported => IP Cameras => DCS-930L => Topic started by: BortFlancrest on October 21, 2015, 07:43:50 PM

Title: Delay after motion is triggered before it looks for motion again
Post by: BortFlancrest on October 21, 2015, 07:43:50 PM

I have a camera set to watch my front door.  If I walk out the door, it triggers correctly and sends me a notification with images.
If I then return inside within about 30 seconds or so, nothing is triggered.   After a couple of minutes it will then pick up motion again.

Is there a way to fix this so that the motion sensor resets after only 10 seconds or so?

Title: Re: Delay after motion is triggered before it looks for motion again
Post by: FurryNutz on October 22, 2015, 07:03:10 AM

If you return in side, is there any motion going on? If there is no montion being detected after you leave the site of the camera, I would think that the camera is working correctly.

Title: Re: Delay after motion is triggered before it looks for motion again
Post by: BortFlancrest on October 25, 2015, 06:44:23 PM

Well I walk outside and shut the door.  So for a good 30 seconds or so there is no movement at all, then the door opens and I walk inside.  This movement is enough to trigger the motion sensor off normally, however not if it happens within this short time-frame.

Title: Re: Delay after motion is triggered before it looks for motion again
Post by: FurryNutz on October 26, 2015, 07:26:33 AM

Does it eventually start to trigger events?
Is the camera set up or a Static IP address?
Is uPnP and uPnP Port Forwarding enabled ON the camera?