D-Link Forums

The Graveyard - Products No Longer Supported => IP Cameras => DCS-2332L => Topic started by: rstark18 on November 30, 2015, 10:08:16 PM

Title: FW 1.07 Bug - Snapshot
Post by: rstark18 on November 30, 2015, 10:08:16 PM

Has anyone else run into this:
When setting up an event to email snapshots of a motion detected and the max number of frames is selected (3 pre & 7 post) it will send 3 pre event images from an earlier event.
I never ran 1.06 so I'm not sure if this bug is in that version. I'll probably load it tomorrow.

Title: Re: FW 1.07 Bug - Snapshot
Post by: FurryNutz on December 01, 2015, 06:42:43 AM

Let us know results if you load v1.06.

Title: Re: FW 1.07 Bug - Snapshot
Post by: rstark18 on December 04, 2015, 05:26:50 PM

Rolled back to 1.06 with same results. Might go back to 1.05

Title: Re: FW 1.07 Bug - Snapshot
Post by: cmontyburns on December 06, 2015, 07:44:05 AM

I've never upgraded mine past 1.03 and I can say the bug doesn't occur there, if you want to go back that far.  :)

Title: Re: FW 1.07 Bug - Snapshot
Post by: rstark18 on March 06, 2016, 04:39:10 PM

Update. I finally had some time to mess with this. I downgraded all the way down to 1.03 and the problem was still there. I decided to take the camera down and do a physical reset as opposed to a software set to factory defaults. That worked. I'm back on 1.07 and images are being sent correctly.

Title: Re: FW 1.07 Bug - Snapshot (RESOLVED)
Post by: FurryNutz on April 06, 2016, 06:35:20 AM

Glad it's working better. Thanks for sharing the process.
Enjoy.