D-Link Forums

The Graveyard - Products No Longer Supported => IP Cameras => DCS-5222L => Topic started by: hophuoc on January 20, 2016, 08:15:37 AM

Title: Setup a preset position after power up again?
Post by: hophuoc on January 20, 2016, 08:15:37 AM

Hi,
My camera is DCS-5222LB1, hardware ver B, firmware 2.11.01
After power down and power up again, the camera runs PTZ to a initial position automatically.
I wish the camera will automatically do PTZ to a preset position that it memorized( I setup before ie: home position) , Not to initial position after re- power.

How can I setup?

Best regards
Thank you

Title: Re: Setup a preset position after power up again?
Post by: FurryNutz on February 08, 2016, 07:10:37 AM

This maybe default settings used for PTZ. You might look in the user manual to see if PTZ can be set to a custom setting, if not then it's by default.