D-Link Forums

The Graveyard - Products No Longer Supported => IP Cameras => DCS-932L => Topic started by: stevew295 on April 25, 2016, 01:28:30 PM

Title: 932L-wireless
Post by: stevew295 on April 25, 2016, 01:28:30 PM
New 932L with latest firmware.  Works fine wired but not wireless.  I searched and saw others with same problem, but not sure my problem is exactly the same. I believe I saw that on other posts, the camera would not hook up wirelessly unless you reduced WPA2.  I haven't tried that, but the setup utilitly DOES find the camera ok, and it does appear that the wireless settings have been applied.  But then get he message "can't connect to mydlink" or some such.  I believe the articles I saw were several years old, can anyone confirm that lowering WPA2 to WPA is the ONLY was to get it to work wirelessy?  Like I said, wired works fine, I can logon to mydlink and view the camera just fine.

Thanks, Steve
Title: Re: 932L-wireless
Post by: FurryNutz on April 25, 2016, 02:09:48 PM
Link>Welcome! (http://forums.dlink.com/index.php?topic=48135.0)


What Mfr and model is the main host router?
What wireless modes are you using?
Can you connect and associate the camera to mydlink.com when it's wired?
Try reducing the WPA mode from WPA2 to WPA and TPIK and test. Then Try Mixed TPIK and AES. Then try WPA2 and TPIK only. Then try WPA2 and AES only and see...
Set radio mode from Mixed to single mode N and test.
Title: Re: 932L-wireless
Post by: FurryNutz on May 31, 2016, 07:31:27 AM
Any status on this?  ???

Quote from: stevew295 on April 25, 2016, 01:28:30 PM
New 932L with latest firmware.  Works fine wired but not wireless.  I searched and saw others with same problem, but not sure my problem is exactly the same. I believe I saw that on other posts, the camera would not hook up wirelessly unless you reduced WPA2.  I haven't tried that, but the setup utilitly DOES find the camera ok, and it does appear that the wireless settings have been applied.  But then get he message "can't connect to mydlink" or some such.  I believe the articles I saw were several years old, can anyone confirm that lowering WPA2 to WPA is the ONLY was to get it to work wirelessy?  Like I said, wired works fine, I can logon to mydlink and view the camera just fine.

Thanks, Steve