D-Link Forums

The Graveyard - Products No Longer Supported => Hubs and Switches => DGS-1248T => Topic started by: andrey.mihaylov on June 16, 2016, 12:56:21 AM

Title: DGS-1210-48 Ports aggregation/separation
Post by: andrey.mihaylov on June 16, 2016, 12:56:21 AM

Hey guys,

First at all i would like to apologize if my question is too dumb... :)
I want to separate aggregate switch by two, for example i used all 48 ports like     Untagged VLAN Ports by default configuration, but i need to use port 33,34,35 and 36 in separated vlan again untaged , the reason that i want  to do that is because i have 2 dhcp servers for different network and i dont  want they are "talk" between. The most obvious way to do this is through a different(separated)  switch and physically aggregation, but if its possible to be use only one will be the best .

Best Regards, and appreciate any help

 

Title: Re: DGS-1210-48 Ports aggregation/separation
Post by: FurryNutz on September 16, 2016, 08:28:00 AM

Any status on this ?