D-Link Forums

The Graveyard - Products No Longer Supported => Routers / COVR => DIR-605L => Topic started by: KAASSS on June 26, 2016, 05:42:07 AM

Title: Configuration Issue
Post by: KAASSS on June 26, 2016, 05:42:07 AM

While configuring this router got below error
wan gateway ip address must be within the wan subnet
This is working fine without router

Service Provider is : Alliance

Title: Re: Configuration Issue
Post by: FurryNutz on June 27, 2016, 07:55:38 AM

Router:
Link>Welcome! (http://forums.dlink.com/index.php?topic=48135.0)

• What Hardware version is your router? Look at sticker under the router case.
• Link>What Firmware (http://forums.dlink.com/index.php?topic=47512.0) version is currently loaded? Found on the routers web page under status.
• What region are you located?

Internet Service Provider and Modem Configurations

• What ISP Service do you have? Cable or DSL?
• What ISP Modem Mfr. and model # do you have?
• If the ISP modem has a built in router, it's best to bridge the modem. Having 2 routers on the same line can cause connection problems: Link>Double NAT (http://www.practicallynetworked.com/networking/fixing_double_nat.htm) and How NAT Works (http://computer.howstuffworks.com/nat.htm). Call the ISP and ask to see if the ISP modem can be bridged. To tell if the modem is bridged or not, look at the routers web page, Status/Device Info/Wan Section, if there is a 192.168.0.# address in the WAN IP address field, then the modem is not bridged. If the modem can't be bridged then see if the modem has a DMZ option and input the IP address the router gets from the modem and put that into the modems DMZ. Also check the routers DHCP IP address maybe conflicting with the ISP modems IP address of 192.168.0.1. Check to see if this is the same on the ISP modem, and if modem can't be bridged, change the DIR router to 192.168.1.1 or .0.254.
  Example of a D-Link router configured for PPPoE with ISP Modem bridged: PPPoE Configuration on a Router (http://forums.dlink.com/index.php?topic=56344.msg219023#msg219023)

Title: Re: Configuration Issue
Post by: FurryNutz on July 25, 2016, 07:01:02 AM

Any status on this?  ???

Quote from: KAASSS on June 26, 2016, 05:42:07 AM

While configuring this router got below error
wan gateway ip address must be within the wan subnet
This is working fine without router

Service Provider is : Alliance