D-Link Forums

The Graveyard - Products No Longer Supported => D-Link Storage => DNS-320L => Topic started by: miracomovoy on September 17, 2016, 12:45:16 AM

Title: NAS LOCKED RED LIGHTS
Post by: miracomovoy on September 17, 2016, 12:45:16 AM

Hello, need help please.
I updated my DLink NAS-320LW and restart the computer can not connect with in any way.
Within the router does not appear, and I get red lights on the site are the hard disk. Is there any way to make a hardreset. I can load the old firmware in any way possible?
Thanks ... (sorry for my English I'm using Google translation)

Title: Re: NAS LOCKED RED LIGHTS
Post by: ivan on September 17, 2016, 02:42:05 AM

The reset button is on the bottom of the unit below the left bottom corner of the label.  Use something small enough to fit through the hole and press the button in for about 10 seconds.  This should restore factory defaults if the new firmware was flashed correctly.

If that does not work you will have to learn about soldering and using a USB/SERIAL 3.3v adapter and uboot.

Title: Re: NAS LOCKED RED LIGHTS
Post by: FurryNutz on September 22, 2016, 06:47:21 AM

Any status on this?  ???

Quote from: miracomovoy on September 17, 2016, 12:45:16 AM

Hello, need help please.
I updated my DLink NAS-320LW and restart the computer can not connect with in any way.
Within the router does not appear, and I get red lights on the site are the hard disk. Is there any way to make a hardreset. I can load the old firmware in any way possible?
Thanks ... (sorry for my English I'm using Google translation)