D-Link Forums

The Graveyard - Products No Longer Supported => Routers / COVR => DIR-330 => Topic started by: bleboeuf on July 17, 2009, 01:55:35 PM

Title: DIR-330 tunnel to a Juniper issues.
Post by: bleboeuf on July 17, 2009, 01:55:35 PM

Hi
I have just bought a DIR-330 to replace a flacky Linksys.  I had linksys elsewhere but this batch looked flacky, so changed to DLINK but not I have issues tunnelling....
Set it up a IPSEC VPN to connect it to my Juniper as much as I could do. 
It does not tunnel in.  It stops at my Phase 1 Proposal.
I have the Preshared key the same in both boxes.
On both boxes it is a Main mode, nat is not enabled, and it is at 1024bit just as it.
I am using only one cipher/hash on the juniper, the Dlink looks sending 4 each time.  Should I put 4 on the juniper?

has anyone connected a DIR-330 to a Juniper?

Thanks

Benoit

Title: Re: DIR-330 tunnel to a Juniper issues.
Post by: Fatman on July 17, 2009, 02:32:43 PM

I have not, but I can tell you that as long as A proposal matches it shouldn't matter which one.