D-Link Forums
The Graveyard - Products No Longer Supported => IP Cameras => DCS-5222L => Topic started by: Patrickthierry on November 03, 2016, 11:58:08 AM
-
Hi,
I bought a second DCS 5222L but I can't install it.
I tried with the WPS and Ethernet cable.
Using WPS I can't say much but the camera and router don't pair.
Using Ethernet cable, the green light does not stay solid but blinking every 3-4 seconds.
I tried for 2 hours now! First camera was install in a minute!!!
Any idea what goes wrong?
-
Turn off first camera and try 2nd only.
Are these 5222lB's?
-
Link>Welcome! (http://forums.dlink.com/index.php?topic=48135.0)
- What Hardware version is your DCS? Look at the sticker behind or under the camera.
- Link>What Firmware (http://forums.dlink.com/index.php?topic=47512.0) version is currently loaded? Found on the DCSs web page under status.
- What region are you located?
What Mfr and model is the main host router?
What wireless modes are you using?
I recommend setting a static IP address ON the cameras outside of the main host routers default DHCP IP address pool as a troubleshooting step: 192.168.#.22 and .23 DHCP (http://forums.dlink.com/index.php?topic=58017.0)
Test cameras with uPnP and uPnP Port Forwarding (http://forums.dlink.com/index.php?topic=37689.0) both enabled on ALL cameras: DCS Cloud (L) Series Camera Configuration and Mydlink.com (http://forums.dlink.com/index.php?topic=62395.0)
Using the latest setup SW on mdlink.com (http://mdlink.com)?
Hi,
I bought a second DCS 5222L but I can't install it.
I tried with the WPS and Ethernet cable.
Using WPS I can't say much but the camera and router don't pair.
Using Ethernet cable, the green light does not stay solid but blinking every 3-4 seconds.
I tried for 2 hours now! First camera was install in a minute!!!
Any idea what goes wrong?