D-Link Forums
The Graveyard - Products No Longer Supported => Routers / COVR => DIR-890L => Topic started by: b17gsr on November 27, 2016, 07:24:12 AM
-
Hi,
I have Gargoyle running on a different router (with parental controls), and use our D-Link DIR-890L/R as an AP. Now that we have a media streamer for our Arris gateway, I have to shuffle my network around to access the media streamer through the DIR-890L/R.
My goal is to have the DIR-890 as router #1 and my Gargoyle router as #2 (as shown in this article).
https://www.dd-wrt.com/wiki/index.php/Linking_Subnets_with_Static_Routes (https://www.dd-wrt.com/wiki/index.php/Linking_Subnets_with_Static_Routes)
The DIR-890L/R would still be in AP mode, since the media streamer needs to be on the same network subnet as the Arris gateway. The Arris gateway configurations are minimal.
Is there a way to add advanced routing options to the DIR-890L/R router (as shown under "Configure Router1 with the following information:")?
-
Is the 890L running in full AP mode using LAN to LAN connections with the main host router? If so, it wouldn't need any static routing.
-
I'm lost. I think they want the 890l in AP mode as the 1st router.
-
Would have to be Router Mode then..
-
Yes, want the DIR-890 Iin AP mode.
Goal was to try to allow traffic from DIR-890 to the Gargoyle router. For the parental controls to work in Gargoyle, it must be in router mode.
-
Put then both in router mode.
Dir 890 is 192.168.1.1
Make gargoyle router mode but tell it to be 192.168.2.1.
-
Catch is media streamer has to be connected to Arris gateway. If there are any "routers" in the network, anything connected to a "router" won't connect to the media streamer.
However I require at least the Gargoyle router in "router" mode to keep the kids in check.
Good old catch 22.
-
If you leave the 890L as a LAN to LAN AP mode unit, then this should work if you connect clients to the 890L and work as a pass thru to the arris router. Also the use of the routers DMZ can be of uses for streamers as well.