D-Link Forums

The Graveyard - Products No Longer Supported => Other D-Link Products => Topic started by: mzangeneh on December 26, 2016, 02:01:03 AM

Title: Extra operator report during in each operation
Post by: mzangeneh on December 26, 2016, 02:01:03 AM

Hi all

I was working with a D-Link dwm-157 with Firmware Version 1.0.1du, I could send sms with at commands and everything were ok,
recently I have bought D-Link dwm-157 with Firmware Version 4.0.2MES, because the old module has been stopped production.

There are little changes between calling a commands in these two modules.
in old one, when I call this:

AT+CUSD=1,"*140#"

I get this output:

OK

+CUSD= 2, "the result of USSD call", 15

But in new module the result is :

+SPNWNAME: "432", "11", "Mci", "Mci"

+CUSD= 2, "the result of USSD call", 15

As you see, in the new module there is an extra report which shows the operator name and network code (+SPNWNAME: "432", "11", "Mci", "Mci"), this query slows down the result of my every at command, could you please help me how can I disable that query to speed up my new module.

Thanks any suggestion in advance.

Title: Re: Extra operator report during in each operation
Post by: FurryNutz on December 26, 2016, 01:22:40 PM

I recommend that you phone contact your regional D-Link support office and ask for help and information regarding this. We find that phone contact has better immediate results over using email.
Let us know how it goes please.