D-Link Forums

The Graveyard - Products No Longer Supported => Routers / COVR => DIR-825 => Topic started by: Harborseal on July 20, 2009, 03:01:28 PM

Title: new 825 upgaded to 2.02, network works but can't login as admin
Post by: Harborseal on July 20, 2009, 03:01:28 PM

I got a DIR-825 B1, saved a configuration, upgraded to 2.02NA.  The firmware upgrade page counted down from 180 to 87 where it froze.  ie froze as well.  I let it run overnight then rebooted everything from my computer to the cable modem.  The network runs fine, including internet.  The loginpage saysit's running 2.02NA.  I tried admin with no password and admin with the old password I put in and neither one works.  Is there a new password to login with 2.02NA?  Thanks.

Title: Re: new 825 upgaded to 2.02, network works but can't login as admin
Post by: TTexas on July 20, 2009, 06:41:43 PM

It should revert to UID:  admin with the PW:  "blank"

Worst case, reset the router via the physical reset button on the back (paperclip depress for 10 seconds) and allow it to reboot and try the above uid/pw again.

Good luck,

TTx

Title: Re: new 825 upgaded to 2.02, network works but can't login as admin
Post by: Harborseal on July 21, 2009, 09:26:46 AM

Well, it went from bad to worse.  All lights out except for dlink blinking blue and power blinking orange.  Spent an hour with TS, no resurrection.  It gets exchanged today.

Title: Re: new 825 upgaded to 2.02, network works but can't login as admin
Post by: claykin on July 22, 2009, 06:09:31 PM

Did the exchange resolve your issue?

Title: Re: new 825 upgaded to 2.02, network works but can't login as admin
Post by: Harborseal on July 22, 2009, 10:53:38 PM

By exchange I meant return the bad model and get a new one.  The new one is working fine (knock on wood!)  I followed the directions to get 300 mb/s - where can I read the speed from?