D-Link Forums

The Graveyard - Products No Longer Supported => Routers / COVR => DGL-4500 => Topic started by: toyceli22 on July 31, 2009, 02:05:20 PM

Title: Virtual Server Rules
Post by: toyceli22 on July 31, 2009, 02:05:20 PM

Hi,

I am currently having a problem with my 4500 and my Windows Home Server.

I created 4 rules (80/443/3389/4125) under "virtual server" and have them all enabled.  After about 30min-1 hour, they get disabled and i have to manually enable them again. 

I have a A1 with 1.21b02.

Any help would be appreciated.

TIA

Title: Re: Virtual Server Rules
Post by: RugidChild on August 04, 2009, 12:59:47 PM

You may want to move your question into the post dealing with the 1.21b02 firmware so they can answer your question for you.

Title: Re: Virtual Server Rules
Post by: arod on August 04, 2009, 01:26:35 PM

toyceli22,

Did you reset the router to factory default then build the config from scratch or did you load a previously saved config?

After enabling the Virtual Server rules did you hit the save settings button? IF so what did the router ask after you enabled/created it?

Do you have any port forwarding rules?

Title: Re: Virtual Server Rules
Post by: toyceli22 on August 04, 2009, 01:30:36 PM

Yup the config was built from scratch after i uploaded this FW.

there was a pop up asking if it was ok to enable the rule.  I click ok and it's enable for a little while but eventually the check in the box goes away.

I have no port forwarding rules setup currently.