D-Link Forums

The Graveyard - Products No Longer Supported => Routers / COVR => DIR-825 => Topic started by: letxob on August 08, 2009, 08:58:38 PM

Title: Inbound filter: how to add more than 8 IP Ranges?
Post by: letxob on August 08, 2009, 08:58:38 PM

I have setup port forwarding to my webserver on port 80.

I wanted to block certain ip ranges from being able to access that webserver.
So I created a filter to deny those ranges and then add that filter to the port forwarding entry.

It seems though that you can only add a max of 8 ip ranges to a rule and only 1 rule to a port forwarding entry.

question is; how can I block more than 8 ip ranges from accessing my webserver?

Title: Re: Inbound filter: how to add more than 8 IP Ranges?
Post by: letxob on August 15, 2009, 05:06:35 AM

What is worse, the ip ranges entered are not blocked consistently, ip's inside the range still get passed to my webserver by this sad excuse for a router, my old di-624 did a better job

Title: Re: Inbound filter: how to add more than 8 IP Ranges?
Post by: letxob on August 16, 2009, 03:56:09 AM

did a new factory reset and reinstalled the entire config from scratch.
Seems the ip blocking is now more consistent, fingers crossed (in my nose actually).

still no clue as to how to block more that 8 separate ip ranges from accessing webservices though.