D-Link Forums
The Graveyard - Products No Longer Supported => IP Cameras => DCS-5020L => Topic started by: berthagomez on December 09, 2017, 05:24:52 PM
-
Hello all you smart cookies! I'm hoping you might be able to share some wisdom and help me out.
I have a DCS 5020L that was working great at my previous home, but I have moved and want to set it up at my new place. The LED is solid red and a factory reset does nothing. When I use a pin to press in the button in the little hole, absolutely nothing happens. The LED doesn't even flicker. I can hear the little button click, and I hold it down for 10 seconds. Nothing. Hold it down for up to a minute. Still nothing.
Is there anything else I can try?
-
Link>Welcome! (http://forums.dlink.com/index.php?topic=49573.0)
- What Hardware version is your DCS? Look at the sticker behind or under the camera.
- Link>What Firmware (http://forums.dlink.com/index.php?topic=47512.0) version is currently loaded? Found on the DCSs web page under status.
- What region are you located?
What Mfr and model is the main host router?
What wireless modes are you using?
-
Hello all you smart cookies! I'm hoping you might be able to share some wisdom and help me out.
I have a DCS 5020L that was working great at my previous home, but I have moved and want to set it up at my new place. The LED is solid red and a factory reset does nothing. When I use a pin to press in the button in the little hole, absolutely nothing happens. The LED doesn't even flicker. I can hear the little button click, and I hold it down for 10 seconds. Nothing. Hold it down for up to a minute. Still nothing.
Is there anything else I can try?
Connect it to your router with an Ethernet cable and then see if you can access the admin interface in your web browser.