D-Link Forums

D-Link Enterprise => DGS-1100-Series => Topic started by: GreenBay42 on January 15, 2018, 09:25:49 AM

Title: Firmware 1.01B020 Released - For 10MP and 26MP Rev B only
Post by: GreenBay42 on January 15, 2018, 09:25:49 AM

This firmware is for the DGS-1100-10MP / 26MP / revision Bx units only.

Release Notes - ftp://FTP2.DLINK.COM/PRODUCTS/DGS-1100-SERIES/REVB/DGS-1100-SERIES_REVB_RELEASE_NOTES_v1.01B020.pdf (ftp://FTP2.DLINK.COM/PRODUCTS/DGS-1100-SERIES/REVB/DGS-1100-SERIES_REVB_RELEASE_NOTES_v1.01B020.pdf)

Firmware - ftp://FTP2.DLINK.COM/PRODUCTS/DGS-1100-SERIES/REVB/DGS-1100-SERIES_REVB_FIRMWARE_v1.01B020.zip (ftp://FTP2.DLINK.COM/PRODUCTS/DGS-1100-SERIES/REVB/DGS-1100-SERIES_REVB_FIRMWARE_v1.01B020.zip)

MIB - ftp://FTP2.DLINK.COM/PRODUCTS/DGS-1100-SERIES/REVB/DGS-1100-SERIES_REVB_MIB_01.B012.zip (ftp://FTP2.DLINK.COM/PRODUCTS/DGS-1100-SERIES/REVB/DGS-1100-SERIES_REVB_MIB_01.B012.zip)

---

Release Notes:

These are changes only for v1.01B020. Please view the release notes (link above) for complete changes since the last official release (v1.00B002).

Bug fix:

• Switch not saving settings to the NV-RAM [HQ20170728000003]
• It is suggested to reset the configuration section in flash by the following steps [DUSA20170725000002-Canada]:
  1. Backup current settings via ‘Configuration Backup’.
  2. Perform 'Reset' > The Switch will be reset to its factory defaults including IP address, and then will save, reboot.
  3. Restore settings via ‘Configuration Restore’.