D-Link Forums

The Graveyard - Products No Longer Supported => Routers / COVR => DIR-625 => Topic started by: subans on August 16, 2009, 09:43:17 AM

Title: Port Forwarding and Virtual Server resets itself.
Post by: subans on August 16, 2009, 09:43:17 AM

Hi there, the problem I'm having is bit crazy..  ???

My Router is Dir - 625. Current firmware is 3.06. with typical router settings with WPA/WPA2 wireless.

My problem is: when I setup Virtual Server, the setting stays on for awhile. then router resets itself and I lose all the virtual server settings. all other settings are intact.

When I do port forwarding, router says I need to reboot and when I do that I lose the setting immediately. when I go back and check the settings I don't see any changes I made in Port Forwarding. all 24 of them are empty.

My ISP is Rogers (Canada) if that helps.

Thank you!!

Title: Re: Port Forwarding and Virtual Server resets itself.
Post by: Wand on November 12, 2009, 03:43:05 PM

There are two firmware revisions since 3.06, they are 3.07 and 3.08.  Reading on this forum 3.08 may be suspect.  I ran 3.07 fine for awhile, someone said 3.06 was the most stable.  Take your pick and let us know what happens.

Title: Re: Port Forwarding and Virtual Server resets itself.
Post by: DarrelH on December 27, 2009, 04:07:35 PM

Had the same problem.  That, along with the Securespot hijacking is why I asked for a replacement.  I'll go hook up the old one to see what rev it is, but I'm pretty sure I ran against to two more recent revs.

Title: Re: Port Forwarding and Virtual Server resets itself.
Post by: bangerboy on December 27, 2009, 05:10:55 PM

I am having the same issue myself Dir 625 version C Firmware is @ 3.06 I save settings and few days later it looses the portforwarding and the virtual. You are certain that 3.07 or 3.08 will solve this issue..
TiA