D-Link Forums
D-Link DSL Modem/Routers => DSL-2740B => Topic started by: boing on March 14, 2018, 02:57:15 AM
-
I have a DSL-2750U router connected to my home WiFi with firmware version ME_1.03
I tried Enabling Access Control Mode
and the web page was loading . . . (i could see it in the browser)
so i closed the router page to check and make a note of my MAC address
the next thing i know I'm locked out.
Not a single device is connecting to the internet but its connecting to the home Wifi
WiFi SSID is still visible and I'm able to connect to the WiFi with password but can't connect to internet or any web pages
Can't even connect to 192.168.1.1 which is the default gateway
I tried even connecting the laptop to the router with LAN cable and it wasn't connecting to the Default Gateway.
i tried search for the default gateway with ipconfig/all in the cmd.exe
and it was showing
Default Gateway : fe80::1%17
192.168.0.254
btw 192.168.0.254 shows the repeater's admin page and can access it (yes i have a WiFi repeater) when connected to the Wifi
Am i missing something?
What's solution for this?
-
Link>Welcome! (http://forums.dlink.com/index.php?topic=49573.0)
- What region are you located?
How as the Access control configured? Sounds like you locked everyone out.
Does a ethernet wired PC connect to the modem and get internet access?
If you can't gain access, you'll need to factory reset the router and set up from scratch.
I would review the user manual on how to configure the access control. Try setting the access control up for just one device if thats possible.
-
Well I'm currently in INDIA
No I didn't configure anything. Just clicked "Enable Access Control" from some tab.
Now i don't even remember which option was it. . i was looking for MAC filter
Try setting the access control up for just one device if thats possible.
how to do if i'm not able to connect to the default gateway even with the LAN cable.
-
You possibly enabled access control and accidentally locked all users out. You will need to reset the router - paperclip in the reset hole - hold for 10 seconds then release. All settings will be deleted so you will need to reconfigure the modem and router settings.
-
Isn't there any other option other than resetting and starting from scratch?
Should i hold the Paperclip while the Unit is "Plugged and ON"?
really worried about electric shocks.. . don't wanna get TASED :o
-
Yes you'll need to factory reset. You can use a paper clip or a pen with a fine point to push in on the button. Its completely safe. Theres now high voltages in side the modem.
-
What all things would i have to do and input if i reset that with a pen (works for me; but still don't wanna get :o)
Please describe it step by step. Don't wanna lose like i did before. :-[
-
Have a Ethernet wired PC connected to the modem and use a web browser to log into 192.168.1.1 I believe. Walk the setup wizard and it will help you get the modem re-installed. Download the user manual as well for additional help and information.
-
Is Ethernet = LAN Cable?
are they the same? :)
User manual url? Dlink support doesn't show the user manuals for D-Link DSL-2750U
-
Yes.
Check with your regional D-Link support site.
http://support.dlink.com/globaldirectory.aspx (http://support.dlink.com/globaldirectory.aspx)