D-Link Forums
The Graveyard - Products No Longer Supported => D-Link Storage => DNS-323 => Topic started by: TomHillebrand on May 16, 2018, 05:45:52 AM
-
Hi UG
My ~6+ old DNS-323 with 2x 1TB in RAID-1 stopped working. AFIK there was no power fault.
Checking the drive the big LED (Power button) was OFF, the little LED (access, underneath Power button) fast blinking.
I powered down, start new:
- The Power LED blinks fast, device is starting
- Power LED blinks slower (at this time DNS120 software can detect device, but I can't map it)
- Power LED goes OFF and Access LED continues to blink fast (DNS can't detect device anymore)
Access via browser/IP address failed
Before I start to try recovery via Ext2IFS I hope someone got a great Idea how to get the DNS-323 accessible again.
Thanks in advance
-
Check the power adapter tip for voltage and amps. Might try a similar power adapter with same specs...
What does the user manual say about LED behaviors?
-
Check the power adapter tip for voltage and amps. Might try a similar power adapter with same specs...
What does the user manual say about LED behaviors?
Difficult to check without specs :-( but PSU seams to be ok
Similar PSU? Plug has 4 Pins. If I would have one "similar" I could blow up the DNS-323 if one Pin has wrong voltage
-
Specs are posted on the sticker on the power supply brick.
-
What does the user manual say about LED behaviors?
Unfortunately nothing. Samples:
Hard Drive is Full An alert will be sent when the hard drive is full.
Critical Error An alert will be sent if a critical error occurs on one of the drives