D-Link Forums

The Graveyard - Products No Longer Supported => Routers / COVR => DIR-825 => Topic started by: guptakaushal009 on December 07, 2018, 02:45:56 AM

Title: IPv6 configuration in DIR-825 AC
Post by: guptakaushal009 on December 07, 2018, 02:45:56 AM

Hi,

I am using D-Link DIR-825 AC router to configure IPv6 dynamically.
I am having IPv4 WAN connection. I want to configure IPv6 dynamically by the router.
WAN  =ipv4=>  ROUTER =ipv6=> SYSTEM(running OS, Want IPv6 IP assigned by router)
Which method is good to go ?

Thanks,
-Kaushal

Title: Re: IPv6 configuration in DIR-825 AC
Post by: FurryNutz on December 07, 2018, 06:32:50 AM

Link>Welcome! (http://forums.dlink.com/index.php?topic=49573.0)

• What Hardware version is your router? Look at sticker under the router case.
• Link>What Firmware (http://forums.dlink.com/index.php?topic=47512.0) version is currently loaded? Found on the routers web page under status.
• What region are you located?

I recommend that you review the user manual for IPv6 setup and configuration.

Title: Re: IPv6 configuration in DIR-825 AC
Post by: guptakaushal009 on December 09, 2018, 09:59:58 PM

Hi,

H/W version :- G1
F/W version :- 7.00
Region:- India

I have gone through manual for IPv6 and configured accordingly but still i am not getting IPv6 address dynamically.

Thanks,
-Kaushal

Title: Re: IPv6 configuration in DIR-825 AC
Post by: FurryNutz on December 10, 2018, 06:39:48 AM

Be sure your PC or device has IPv6 enabled as well...
Does your ISP support native IPv6 from there services?

Title: Re: IPv6 configuration in DIR-825 AC
Post by: GreenBay42 on December 10, 2018, 08:03:12 AM

So you want just your local network IPv6?  Not a common setup.

In the IPv6 section, next to My IPv6 Connection select "local connectivity only". 

Title: Re: IPv6 configuration in DIR-825 AC
Post by: guptakaushal009 on December 11, 2018, 12:30:16 AM

ISP doesn't support IPv6.
Is there any option to get IPv6 dynamically by the router if we do connect IPv4 from WAN to router ?
Setup:
     WAN      ==ipv4=>     ROUTER    ==ipv6=>     SYSTEM (need IPv6 address by the router)

It's just for some experiment.

Thanks,
-Kaushal

Title: Re: IPv6 configuration in DIR-825 AC
Post by: FurryNutz on December 11, 2018, 06:37:49 AM

Setting "local connectivity only" should get a dynamic IPv6 IP address from the router.