D-Link Forums
D-Link VPN Router => DSR-250 => Topic started by: Vitaly on September 29, 2020, 08:12:23 AM
-
Hi All,
At my site we have few electronic systems connected by Ethernet. My old TP-link router did the all necessary job and port forwarding as well. During the renovation of IT system, we have changed the old TP-link router on the new DSR 250 and I got an issue with port forwarding.
Router: DSR 250, Firmware: 3.14B103H
My internal equipment sited on IP: 192.168.10.150
Communication port: 80
At the DSR 250 I want to use port 8095 for the forwarding to IP 192.168.10.150 port 80
My settings in Security section:
________________________________________________
Custome Service Configuration
- Name: ConrWebAccess
- Port Range
Source Start Port: 1
Source Finish Port: 65535
Destination Start Port: 8095
Destination Finish Port: 8095
_____________________________________________________
And
_____________________________________________________
Firewall Rules Configuration
From Zone: INSECURE (WAN)
To Zone: SECURE (LAN)
Service: ContrWebAccess
Action: Always Allow
Source Hosts: Any
Lag: Never
Destination NAT Settings
Internal IP Address: 192.168.10.150
Enable Port Forwarding: ON
Translate Port Number:80
____________________________________________
But unfortunately I don’t get result.
Maybe I have missed some checkmarks or other restrictions?
I will appreciate for any help or advise with my case!
Many thanks!
-
Is the device that is using 192.168.10.150 configured for port 80? If so change it to 8095 on that device. Also recommend upgrading the DSR-250 to latest firmware depending on what hardware Rev you have.
-
DSR 250 HW Ver A4 , firmware was 3.14 , updated to 3.17, after that Port Forward start to working, I downloaded from d-link web site. firmware update on dsr-250 web control did not show it has new updated firmware available.
-
Glad firmware updated fixed port forwarding issue you were having. Depending on what browser might show cashe information. Delete browser history, refresh or close out browser and then open and log back in to check firmware version for your A4 should show 3.17 now.