D-Link Forums
Eagle Pro AI => R15 => Topic started by: davevt31 on September 18, 2021, 04:03:35 PM
-
Installed 1.02.09 haven't seen any improvement in QOS and still not getting IPv6 address. Also ICMP is still active as it still fails Shields Up test. I did not do a Factory reset after upgrade but will do one later when less people are connected to my network.
-
Factory Reset and complete setup from scratch has fixed the ICMP issue. IPv6 and QOS Speedtest still not ready for prime time.
-
You have to do a factory reset for the ICMP to be blocked etc.?
That's no good...while its easy to set up.. can't say I want to go set it up again LOL.
That would especially not be very nice if you had a bunch of FW rules, port forwards etc.
I just looked and noticed mine auto updated even though I have that disabled..
-
@dave - I get IPv6 addresses (last 2 firmware updates). We may need to look into your setup more.
@sh0nuff - I agree having to reset after a firmware update is not ideal. I know in some cases it is required unfortinately. I will verify/report the auto update issue.
-
The IPv6 settings are exactly the same as my X5460 and it picks an address up right away.
-
When you replace with the R15, do you reboot your modem?
I know you have stated before but what modem and isp do you have?
-
Yep fully power off modem, Spectrum. Modem is Arris SB6183
-
That is exactly my set up too at home. I will bring the router home tonight and check the ipv6 settings.
-
Mine was set for Auto detect, all options enabled and SLAAC + Stateless DHCP for auto config options. This is the setting on my X5460 and it picks up an address. On the R15 it says disconnected. I tried switching to auto configuration instead of auto detect because this work in the past when testing the covr routers but it just says connecting but never actual connects.