D-Link Forums

The Graveyard - Products No Longer Supported => Routers / COVR => DIR-615 => Topic started by: relaxing101 on October 17, 2009, 12:42:50 PM

Title: Updating from a DI-624 to a DIR-615 with existing home wireless network
Post by: relaxing101 on October 17, 2009, 12:42:50 PM

 :(  Help please!  I have an existing (and working just fine) home wireless network using the DI-624 (G) but I am hoping that the DIR-615 (N) will give me more reliable access from my front living area than the DI-624 does.  What do I need to do to make the change?  Do I need to uninstall the 624 before I do anything with the new 615? 

Your assistance is greatly appreciated.

Thank you,

Title: Re: Updating from a DI-624 to a DIR-615 with existing home wireless network
Post by: lynn893 on October 18, 2009, 03:00:37 PM

I would also love to hear the answer to this question, as I'm in the same boat.



I actually uninstalled my trendnet wireless G router in Network Connections and then followed the Guide installation instructions after plugging my wireless laptop into the main internet box from rogers.

I am now connected via the new DIR-615, but not wirelessly! I have gone into the IP address listed for the DIR-615 router and configured it, and was able to connect wirelessly for a couple minutes, but have since been dropped and now absolutely cannot connect wirelessly again.

Are there any users out there who can offer advice? I have three computers that were previously connected wirelessly to a G router, and would love to not return this N and re-install the G.

Thanks!