D-Link Forums
The Graveyard - Products No Longer Supported => D-Link Storage => DNS-323 => Topic started by: MushiSushi on November 14, 2009, 08:51:46 AM
-
Is there a way to reset/reinstall everything except for my documents on the dns323?
I tried reset facory defaults and that didn't solve my issues. Should I try flashing the firmware?
-
As far as I know a reset to factory defaults resets everything other than the disk configuration - which the unit will read from the disks on the next boot up.
Passwords, users, groups, ip address, etc., - are all reset - however - if you are running fun_plug, which loads from the disk after boot up, this will still run.
What "issues" are you having?
-
For some reason, samba is running at 80-100% when I check the processes. I don't know what it is doing.
-
For you to know the utilization, you'd have to be running fun_plug - to get rid of fun_plug, you'd have to delete (or rename) the fun_plug script that runs at start up.
You need to be aware that fun_plug is not supported by DLink and any side effects caused by fun_plug will likewise not be supported, so this forum may not be the best place to seek help.
Can fun_plug be the cause of your problem? Maybe, maybe not - what your fun_plug does is dependent on what you (or whoever created it) told it to do.
There is an inherent danger in "hacking" a piece of hardware, and one of those dangers is that you become the person responsible for what you create, so when you create a problem, it's yours to resolve.