Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[samboscully]

I just installed the 1.2 firmware for my 5300g, revision A.

It is working, but when I go to the page:
"DDNS & UPnP Settings"

whenever I enter the required info in there and hit apply, it refuses to accept the changes. The screen just stays the same and in the bottom of the browser it says:

waiting for: xxxxxxx/setup/ddns.cgi..

(xxxxxx is the ip address of the cam on my network)

Why won't this page update? Everything else seems to work fine. Everything worked fine before I updated the firmware to 1.2.

I guess I will have to revert back to the original firmware. The reason I updated in the first place is because I was having the camera lock up every few days, which required me to power cycle it.

I was hoping the new firmware might fix it. But from what I am reading on here, it sounds like the 5300g has problems when using Dlink routers. I recently "upgraded" to a DIR 825 in order to get gigabit ethernet ports, so that is probably my problem with the lockups.

Pathetic that they can't make their products compatible with each other.

[samboscully]

Well everything works normal after reflashing to the original firmware.

The only thing I can think of is that I should have reset to factory defaults after upgrading the first time. But I'm not going to bother trying it again until I get my wired network up and running.

Hopefully the freeze-ups stay to a minimum so I don't have to keep pulling the power cord out every few days.