• February 23, 2025, 08:04:24 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Autodetect won't work  (Read 3703 times)

dvera

  • Level 1 Member
  • *
  • Posts: 2
Autodetect won't work
« on: March 14, 2011, 09:06:46 PM »
I having issues with DView 3.11 on a WinXP Professional with SP3.
There are 4 DCS 5300G cameras wired to the router.

I can see the cameras using IE, but when I try to configure the DView in the camera section with the autodetect button it will show an error that the camera cannot be identified.

I had checked the IP address, port, user & pass everything is ok. I even hard reseted one of the cameras and it won't work.

Any ideas where I can workaround?

Thanks.
Logged

disaster

  • Level 1 Member
  • *
  • Posts: 24
Re: Autodetect won't work
« Reply #1 on: March 29, 2011, 02:44:10 PM »
Not sure, but it may be your network ID.  The router name used in Explorer must be the same name as in D-ViewCam.  I replaced my router recently & since I didn't remember the name of my old router I called the new one something else & D-ViewCam couldn't find the camera, even though the Setup wizard found it JUST fine.

When I changed the name of the router in D-ViewCam (somewhere in the config pages) to match the new router name, BANG the camera was there.

Good Luck
Logged