I had a drive failure last week, powered down and waited for the new one to arrive. Popped it in on Thursday and let the RAID begin a rebuild.
- On Monday (4 days later) I noticed the NAS had never gone into standby mode and logged in to check it out: 93 minutes remaining on the rebuild.
- I checked it again Tuesday morning: 92.1 minutes remaining.
- I forced a reboot Tuesday evening when it still said 92 minutes remaining
- I checked late Tuesday night and the sync said 200+ minutes remaining, figured all was fine
- I checked Wednesday morning and it was hung at 91'ish minutes again, rebooted again
- I checked again tonight (Thursday)... 92.3 minutes remaining again
What gives? They are 500GB drives that only have about 130GB of data on them. That thing should rebuild in hours, not days... and why does it keep getting stuck at 92'ish minutes?
No failures in the logs, current status below. Thanks for the help.
----------------------------
DEVICE INFORMATION :
View a summary of device information here.
LAN INFO :
IP Address: 192.168.0.199
Subnet Mask: 255.255.255.0
Gateway IP Address: 192.168.0.1
Mac Address: xx:xx:xx:xx:xx:xx
DNS1: 192.168.0.1
DNS2:
DEVICE INFO :
Workgroup: xxxxxxxxxx
Name: NAS
Description: DNS-323 Networked Storage
System Temperature:
111°F / 44°C
Current Rx/Tx: 790577/612224
System Up Time: 1 day 1 hour 47 minutes
USB DEVICE INFO :
Manufacturer: None
Product: None
HARD DRIVE INFO :
Total Drive(s): 2
Volume Name: Volume_1
Volume Type: RAID 1
Sync Time Remaining: 94.8 minute(s)
Total Hard Drive Capacity: 490402 MB
Used Space: 139494 MB
Unused Space: 350908 MB
PHYSICAL DISK INFO :
Slot Vendor Model Serial Number Size
Right WDC WD5000AAKS-00YGA WD-WCAxxxxxxxxx 500 G
Left WDC WD5000AAKX-001CA WD-WCAxxxxxxxxx 500 G
Author
Topic: RAID never finishes rebuilding (Read 3241 times)