Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[net_tech]

is there anything i can tweak in the config on my 3200 ap (fw2.55) to get better speeds for my wireless clients. i am only getting 2MB/s when copying file from a wired computer to a wireless laptop connected at 54mb/s with excelent signal. I was hopping to see speeds anywhere from 5-7MB/s when only 1 wireless client is connected. 

D-Link Access Point wlan1 -> get config
wlan1 revisions: mac 5.8 phy 4.4 analog 4.6
  PCI Vendor ID: 0x168c, Device ID: 0x13
  Sub Vendor ID: 0x168c, Sub Device ID: 0x13
chip is AR2312
Country Code: US
Operation Mode: Access Point
Wlan State: Enabled
Radio Frequency: 2437 MHz (IEEE 6)
Wireless LAN Mode: 802.11g
Auto Channel Select: Enabled
Extended Channel Mode: Enabled
Data Rate: best
Antenna: best
Login Username: admin
RADIUS address:
Name server IP address:
Name server domain suffix:
SSID: WL02
SSID Suppress Mode: Disabled
System Name: D-Link Access Point
Beacon Interval: 100
DTIM: 1
Fragmentation Threshold: 2346
RTS/CTS Threshold: 2346
Short Preamble: Enabled
11g Only Allowed: Disabled
CTS Mode: AUTO
CTS Rate: 11 Mbps
CTS Type: CTS-ONLY
11g Overlapping BSS Protection: Disabled
11g Beacon Rate: 1 Mbps
11g Draft 5.0 compatibility: Disabled
Short Slot Time: Enabled
Basic 11g Rate Set: (1, 2, 5.5, 11)
11g Optimization Level: 1
Burst Time: 2
Burst Sequence Threshold: 3
IP Address: 192.168.50.50
IP Mask: 255.255.255.0
Host IP Address: 0.0.0.0
Gateway IP Address: 192.168.50.1
SNTP/NTP Server IP Address: 192.168.50.5
Time Zone: 14
HW Transmit Retry Limit: 4
SW Transmit Retry Limit: 3
TransmitPower: full
Current Transmit Output Power 21.0 dBm
SuperG :Disabled
Encryption: Enabled
Cipher selection: AUTO
Authentication Type: WPA2-PSK
Default transmit key: 1
Shared Key  1, size  40, 0000000000
Access Check: Disabled
Key Entry Method: hexadecimal
Group Key Update Interval: 1800 seconds
Key Source: server
Aging Interval: 300 seconds
Telnet Access: Enabled
Telnet Timeout: 180 seconds
Minimum rate: 1 Mbps
XR Poll interval: 100 msec
XR Frame Limit: 25
XR Poll Rate String is 0.25 1 1 3 3 6 6 20
XR Fragmentation Threshold: 540

[jasolution]

I don't have any suggestions, but am battling the same problem. The DWL-3200AP is painfully slow.

[plexorab]

Same here! I'm using my DWL-3200AP as an accesspoint only. It seems to be the wired ethernet connection that is the problem. SSH connection through wired ethernet is extremly slow as well ?