• February 23, 2025, 04:06:58 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: WPS on DAP1522  (Read 5055 times)

NigelF

  • Level 1 Member
  • *
  • Posts: 1
WPS on DAP1522
« on: November 23, 2011, 03:26:10 PM »
OK so I turned it on for bridging and it did not auto setup wireless so i need to turn off WPS but my wireless option page is now blank. I rebooted, reset the DAP but still no manual config option. I found I could configure it if I switched it to AP mode but still cannot setup from bridge mode. According to manual a reset does not turn off WPS so what is the answer please?
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: WPS on DAP1522
« Reply #1 on: November 25, 2011, 09:40:48 AM »
Turn OFF WPS, as it's only needed for wireless printers and devices like that. Most of the security is run thru the wireless using WPA and it's security settings there. Just use a password and you'll be good.
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.